Belt Furnace Systems

BELT FURNACES - Thick Film Drying Furnaces

FAST THERMAL RESPONSE:

Chamber is equipped with far infrared quartz heating tube. Infrared radiation penetrates the treated material more easily, which decreases treatment time and energy consumption.

UNIFORM AND STABLE TEMPERATURE CONTROL:

The furnace is monitored by type "K" thermocouples in the center of each heated zone. Each temperature zone is controlled by its own SHIMADAN SR94 single loop intelligent temperature controller with full auto-turning PID. The single wave, zero trigger method enables precise and stable temperature control, avoiding damages to the peripheral equipment and prolonging the life of controlling devices at the same time.

CONVEYOR SYSTEM:

The furnace belt is balanced spiral Nichrome B mesh. Belt speed is programmable in IPM with readout on the monitor. Step less speed regulation is controlled by FUJI frequency converter and is digitally displayed. Deviation from set point alarm is also programmable.

VENTILATION SYSTEM:

Wet gas emissions get non-contact access to the user's exhaust systems. Pumping capacity exceeds 500 CMPH.

MODELS:

MODEL      CONTROL           BELT                 OVERALL             TUNNEL            MAX

                    ZONES         WIDTH              LENGTH             HEIGHT          TEMP

CST  7090         3          300mm  (11.8")     3260mm  (128")     30mm (1.18")      400°C

CST  7091         4         550mm  (21.6")     4890mm (192.5")    40mm  (1.57")     400°C

The CST Research & Development Department is at the advance stages of developing new innovations.